D-Link xStack DGS-3400 Series Reference Manual page 481

xStack
DGS-3450:admin# show per_queue bandwidth_control 1:10
Command: show per_queue bandwidth_control 1:10
Queue Bandwidth Control Table On Port: 1:10
Queue Min_Rate (64Kbit/sec)
---- ---------------------
0 640 no_limit
1 640 no_limit
2 640 no_limit
3 640 no_limit
4 640 no_limit
5 no_limit
6 no_limit
DGS-3450:admin#
config dscp trust
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable DSCP trust on ports 1:1-1:8:
DGS-3450:admin#config dscp trust 1:1-1:8 state enable
Command: config dscp trust 1:1-1:8 state enable
Success.
DGS-3450:admin#
show dscp trust
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display DSCP trust status on ports 1:1-1:8:
®
DGS-3400 Series Layer 2 Gigabit Ethernet Managed Switch CLI Manual
Max_Rate (64Kbit/sec)
----------------------
no_limit
no_limit
Used to configure the state of DSCP trust per port.
config dscp trust [<portlist> | all] state [enable | disable]
When DSCP is not trusted, 802.1p is trusted.
<portlist> - Enter the list of port used for this configuration here.
all - Specify that the command apply to all ports on the Switch.
state - Enable or disable to trust DSCP. By default, DSCP trust is disabled.
Only Administrator and Operator-level users can issue this command.
Used to display DSCP trust state for the specified ports on the Switch.
show dscp trust {<portlist>}
This command is used to display DSCP trust state for the specified ports on the Switch. If not
specify the port, all ports for DSCP trust status on the Switch will be displayed.
<portlist> - A range of ports to display.
None.
477