D-Link xStack DGS-3400 Series Reference Manual page 476

xStack
config 802.1p user_priority
Restrictions
Example usage:
To configure an 802.1p user priority of 1 and a class_ID of 3 on port 1:1:
DGS-3450:admin# config 802.1p user_priority ports 1:1 1 3
Command: config 802.1p user_priority ports 1:1 1 3
Success.
DGS-3450:admin#
show 802.1p user_priority
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
In the case of Project only support global configuration, display the 802.1p user priority:
DGS-3450:admin#show 802.1p user_priority 1:1
Command: show 802.1p user_priority 1:1
QOS Class of Traffic
Port 1:1
Priority-0 ->
Priority-1 ->
Priority-2 ->
Priority-3 ->
Priority-4 ->
Priority-5 ->
Priority-6 ->
Priority-7 ->
DGS-3450:admin#
config 802.1p default_priority
Purpose
Syntax
Description
®
DGS-3400 Series Layer 2 Gigabit Ethernet Managed Switch CLI Manual
class_id - The number of the switch's hardware priority queue. The switch has 7 hardware
priority queues available. They are numbered between 0 (the lowest priority) and 6 (the
highest priority).
Only Administrator and Operator-level users can issue this command.
Used to display the 802.1p user priority.
show 802.1p user_priority {<portlist>}
The show 802.1p user_priority command displays 802.1p user priority for ports.
portlist - Specifies the range of ports to be displayed.
If no portlist is specified, this command will display the 802.1p user priority for all ports.
Only Administrator and Operator-level users can issue this command.
<Class-2>
<Class-0>
<Class-1>
<Class-3>
<Class-4>
<Class-5>
<Class-6>
<Class-6>
Used to configure the 802.1p default priority settings on the Switch. If an untagged packet is
received by the Switch, the priority configured with this command will be written to the
packet's priority field.
config 802.1p default_priority [ <portlist> | all ] <priority 0-7>
The configure 802.1p default_priority command allows you to specify default priority handling
472