D-Link xStack DGS-3400 Series Reference Manual page 176

xStack
DGS-3450:admin# config dhcp pool netbios_name_server accounting 10.98.254.2
Command: config dhcp pool netbios_name_server accounting 10.98.254.2
Success.
DGS-3450:admin#
config dhcp pool netbios_node_type
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure the Net BIOS node type for the DHCP pool:
DGS-3450:admin# config dhcp pool netbios_node_type accounting hybrid
Command: config dhcp pool netbios_node_type accounting hybrid
Success.
DGS-3450:admin#
config dhcp pool network_addr
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure the network address for the DHCP pool:
®
DGS-3400 Series Layer 2 Gigabit Ethernet Managed Switch CLI Manual
Used to set the Net BIOS node type for the DHCP server.
config dhcp pool netbios_node_type <pool_name 12> [broadcast | peer_to_peer |
mixed | hybrid]
This command is used to allow users to set the type of node server for the previously
configured Net BIOS Name server. The user has four choices for node types which are
Broadcast, Peer to Peer, Mixed and Hybrid.
<pool_name 12> − Enter the previously created pool name for which to set the Net BIOS
node type for DHCP clients.
[broadcast | peer_to_peer | mixed | hybrid] – Users may choose the node type for the Net
BIOS from one of the four listed.
Only Administrator and Operator-level users can issue this command.
Used to configure the network address and corresponding subnet mask for the DHCP pool.
config dhcp pool network_addr <pool_name 12> <network_address>
This command will allow users to enter the IP address pool to be assigned to requesting
DHCP Clients. This address will not be chosen but the first 3 sets of numbers in the IP address
will be used for the IP address of requesting DHCP Clients. (ex. If this entry is given the IP
address 10.10.10.2, then assigned addresses to DHCP Clients will resemble 10.10.10.x,
where x is a number between 1 and 255 but does not include the assigned 10.10.10.2)
<pool_name 12> − Enter the previously created pool name for which to set the network
address.
<network_address> − IP address and netmask that is the address of this DHCP pool. The
address and mask information can be specified using the traditional format (for example,
10.1.2.3/255.0.0.0 or in CIDR format, 10.1.2.3/8).
Only Administrator and Operator-level users can issue this command.
172