D-Link xStack DGS-3400 Series Reference Manual page 527

xStack
DGS-3450:admin# config sflow counter_poller ports 1 interval disable
Command: config sflow counter_poller ports 1 interval disable
Success.
DGS-3450:admin#
delete sflow counter_poller
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
Delete sFlow counter poller on port 1:
DGS-3450:admin# delete sflow counter_poller ports 1
Command: delete sflow counter_poller ports 1
Success.
DGS-3450:admin#
create sflow analyzer_server
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To create the analyzer_server:
®
DGS-3400 Series Layer 2 Gigabit Ethernet Managed Switch CLI Manual
Used to delete the sFlow counter poller.
delete sflow counter_poller ports [<portlist> | all]
Delete the sFlow counter_poller from the specified port.
None.
Only Administrator and Operator-level users can issue this command.
Used to create the analyzer server.
create sflow analyzer_server < value 1-4 > owner<name 16> {timeout [<sec m-n> |
infinite] | collectoraddress [<ipaddr> | <ipv6addr>] | collectorport <udp_port_number 1-
65535> | maxdatagramsize < value m-n>}
Creates the analyzer_server. You can specify more than one analyzer_server with the same
IP address but with different UDP port numbers. You can have up to four unique
combinations of IP address and UDP port number.
owner - The entity making use of this sFlow analyzer_server. When owner is set or modified,
the timeout value will become 400 automaticly.
timeout - The length of time before the server is timed out. When the analyzer_server times
out, all of the flow_samplers and counter_pollers associated with this analyzer_server will be
deleted. If not specified, its default value is 400.
collectoraddress - The IP address of the analyzer_server. If this is set to 0 or not specified,
the IPv4 address is 0.0.0.0 and the entry is not active. It is not only IPv4 address, but also
IPv6 address.
collectorport - The destination UDP port for sending the sFlow datagrams. If not specified, the
default value is 6364.
maxdatagramsize - The maximum number of data bytes that can be packed in a single
sample datagram. If not specified, the default value is 1400.
Only Administrator and Operator-level users can issue this command.
523