D-Link xStack DGS-3400 Series Reference Manual page 311

xStack
DGS-3450:admin# config address_binding ip_mac ports 1 state enable
Command: config address_binding ip_mac ports 1 state enable
Success.
DGS-3450:admin#
create address_binding ip_mac
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To create an IMPB entry:
DGS-3450:admin#create address_binding ip_mac ipaddress 10.1.1.1 mac_address 00-00-00-00-
00-11
Command: create address_binding ip_mac ipaddress 10.1.1.1 mac_address 00-00-00-00-00-11
Success.
DGS-3450:admin#
create address_binding ip_mac
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To create an IMPB entry:
®
DGS-3400 Series Layer 2 Gigabit Ethernet Managed Switch CLI Manual
Used to create an IMPB entry.
create address_binding ip_mac ipaddress < ipaddr > mac_address < macaddr > {ports
[ portlist | all]
Use this command to create an IMPB entry.
One MAC address can map to multiple IP addresses.
ipaddr - Specify the IP address used for the IMPB entry.
macaddr - Specify the MAC address used for the IMPB entry.
ports - Specify the portlist the entry will apply to. If no ports are specified, the settings will be
applied to all ports.
Only Administrator and Operator-level users can issue this command.
Used to create an IMPB entry.
create address_binding ip_mac [ipaddress < ipaddr > | ipv6address <ipv6addr>]
mac_address < macaddr > { ports [ portlist | all]}
Use this command to create an IMPB entry.
One MAC address can map to multiple IP address
ipaddr - Specify the IP address used for the IMPB entry.
ipv6addr - Specify the IPv6 address used for the IMPB entry.
macaddr - Specify the MAC address used for the IMPB entry.
ports - Specify the portlist the entry will apply to. If not ports are specified, the settings will be
applied to all ports.
Only Administrator and Operator-level users can issue this command.
307