D-Link xStack DGS-3400 Series Reference Manual page 587

xStack
show time
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To show the time currently set on the Switch's System clock:
DGS-3450:admin# show time
Command: show time
Current Time Source
Boot Time
Current Time
Time Zone
Daylight Saving Time
Offset in minutes : 60
Repeating
Annual
DGS-3450:admin#
config sntp ipv6server
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure SNTP (primary IPv6 server: 1000::1, secondary IPv6 server: 1000::2):
DGS-3450:admin#config sntp ipv6server primary 1000::1 secondary 1000::2
Command: config sntp ipv6server primary 1000::1 secondary 1000::2
Success.
DGS-3450:admin#
®
DGS-3400 Series Layer 2 Gigabit Ethernet Managed Switch CLI Manual
Used to display the current time settings and status.
show time
This will display system time and date configuration as well as display current system time.
None.
None.
: System Clock
: 27 Nov 2008
: 27 Nov 2008
: GMT +00:00
: Disabled
From : Apr 1st
To : Oct last Sun 00:00
From : 29 Apr 00:00
To : 12 Oct 00:00
Used to configure the IPv6 server for the SNTP function.
config sntp ipv6server {primary <ipv6addr> | secondary <ipv6addr>}
If both IPv4 and IPv6 servers are configured, the IPv4 server has the higher priority, it first
sync its time to the IPv4 server.
primary <ipv6addr> - Specifies the primary SNTP IPv6 server address.
secondary <ipv6addr> - Specifies the secondary SNTP IPv6 server address.
Only Administrator and Operator-level users can issue this command.
09:33:16
16:17:45
Sun 00:00
583