D-Link xStack DGS-3400 Series Reference Manual page 432

xStack
DGS-3450:admin# config igmp_snooping multicast_vlan v1 member_port 1:1,1:3 state enable
Command: config igmp_snooping multicast_vlan v1 member_port 1:1,1:3 state enable
Success.
DGS-3450:admin#
config igmp_snooping multicast_vlan_group
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To add an IGMP snooping multicast vlan group to a multicast VLAN group with the name "v1":
DGS-3450:admin# config igmp_snooping multicast_vlan_group v1 add 239.1.1.1
Command: config igmp_snooping multicast_vlan_group v1 add 239.1.1.1
Success.
DGS-3450:admin#
show igmp_snooping multicast_vlan_group
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To show all IGMP snooping multicast VLAN groups setup on the switch:
®
DGS-3400 Series Layer 2 Gigabit Ethernet Managed Switch CLI Manual
Used to configure the IGMP multicast groups learned with the specified multicast VLAN.
config igmp_snooping multicast_vlan_group <vlan_name 32> [add
<mcast_address_list> | delete <mcast_address_list> | delete_all]
Used to configure the multicast group learned with the specific multicast VLAN. The following
two cases can be considered for examples:
Case 1- The multicast group is not configured, multicast VLANs do not have any member
ports overlapping and the join packet received by the member port is learned on only the
multicast VLAN that this port is a member of.
Case 2-The join packet is learned with the multicast VLAN that contains the destination
multicast group. If the destination multicast group of the join packet cannot be classified into
any multicast VLAN to which this port belongs, then the join packet will be learned on the
natural VLAN of the packet.
vlan_name - The name of the multicast VLAN to be configured. Each multicast VLAN is given
a name of up to 32 characters.
add - Add a list of MAC addresses.
delete – Delete a list of MAC addresses.
Only Administrator and Operator-level users can issue this command.
Used to show an IGMP snooping multicast VLAN group.
show igmp_snooping multicast_vlan_group {< vlan_name 32> }
The show igmp_snooping multicast_vlan_group command allows you to show the multicast
VLAN groups.
<vlan_name 32> - Specify the name of the multicast VLAN to be displayed.
Only Administrator and Operator-level users can issue this command.
428