D-Link xStack DGS-3400 Series Reference Manual page 129

xStack
AIS PDUs Transmitted: 0
LCK PDUs
LCK PDUs Transmitted: 0
DGS-3450:admin#
show cfm fault
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To show the CFM faults:
DGS-3450:admin#show cfm fault
Command: show cfm fault
MD Name MA Name
----------- ----------- ----- ---------------------- ------------ ------------
op_domain op1
DGS-3450:admin#
show cfm port
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To show the MEPs and MIPs created on a port:
®
DGS-3400 Series Layer 2 Gigabit Ethernet Managed Switch CLI Manual
: 0 received
Used to show the MEPs that have faults.
show cfm fault {md [<string 22> | md_index <uint 1-4294967295>] {ma [<string 22> |
ma_index <uint 1-4294967295>]}}
This command is used to display all the fault conditions detected by the MEPs contained in a
specified MA or MD.
The displayed output provides the overview of the fault status by MEPs.
md <string 22> - Specify the maintenance domain name.
md_index <uint 1-4294967295> - Specify the maintenance domain index.
ma <string 22> - Specify the maintenance association name.
ma_index <uint 1-4294967295> - Specify the maintenance association index.
None.
MEPID Status
1 Cross-connect CCM Received
Used to show the MEPs and MIPs created on a port.
show cfm port <port> {level <int 0-7> | direction [inward | outward] | vlanid <vlanid1-
4094>}
This command is used to show the MEPs and MIPs created on a port.
port <port> - Specify the port number.
level <int 0-7> - Specify the maintenance domain level.
direction - Specify the MEP direction.
•
inward – Specify the inward facing (up) MEP.
•
outward – Specify the outward facing (down) MEP.
Vlanid <vlanid 1-4094> - Specify the VLAN identifier. If not specified, all VLANs are shown.
None.
AIS Status
125
LCK Status