Dhcpv6 Client Commands - D-Link xStack DGS-3400 Series Reference Manual

xStack
The DHCPv6 Client commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in
the following table.
Command
debug dhcpv6_client state
debug dhcpv6_client output
debug dhcpv6_client packet
Each command is listed, in detail, in the following sections.
debug dhcpv6_client state
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enabled the DHCPv6 client debug function:
DGS-3450:admin# debug dhcpv6_client state enable
Command: debug dhcpv6_client state enable
Success.
DGS-3450:admin#
debug dhcpv6_client output
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To set debug information to output to console:
®
DGS-3400 Series Layer 2 Gigabit Ethernet Managed Switch CLI Manual
Parameters
[enable | disable]
[buffer | console]
{all | receiving| sending} state [enable | disable]
Enable or disable the DHCPv6 client debug function.
debug dhcpv6_client state [enable | disable]
Use this command to enable or disable the DHCPv6 client debug function.
state - See below:
enable - Enable the DHCPv6 client debug function.
disable - Disable the DHCPv6 client debug function.
Only Administrator and Operator-level users can issue this command.
Used to set the debug message to output to buffer or console.
debug dhcpv6_client output [buffer | console]
Set message output to buffer or console.
buffer - Let the debug message output to buffer.
console - Let the debug message output to console.
Only Administrator and Operator-level users can issue this command.
DHCP
V
181
23
6 C C
LIENT OMMANDS