D-Link xStack DGS-3400 Series Reference Manual page 496

xStack
Example usage:
To configure an RSPAN source entry without source target port:
DGS-3450:admin#config rspan vlan vlan_name vlan2 source add ports 2-5 rx
Command:config rspan vlan vlan_name vlan2 source add ports 2-5 rx
Success.
DGS-3450:admin#
To configure an RSPAN source entry for per flow RSPAN, without any source ports:
DGS-3450:admin#config rspan vlan vlan_id 2 source
Command:config rspan vlan vlan_id 2 source
Success.
DGS-3450:admin#
To configure an RSPAN entry on a source with mirror group ID:
DGS-3450:admin#config rspan vlan vlan_id 2 source mirror_group_id 3
Command:config rspan vlan vlan_id 2 source mirror_group_id 3
Success.
DGS-3450:admin#
config rspan vlan redirect
Purpose
Syntax
Description
Parameters
Restrictions
®
DGS-3400 Series Layer 2 Gigabit Ethernet Managed Switch CLI Manual
Used by the intermediate or last switch to configure the output port for the RSPAN mirrored
packet.
config rspan vlan [vlan_name <vlan_name> | vlan_id <vlanid 1-4094>] redirect [add |
delete] port <port>
This command is used by the intermediate or last switch to configure the output port of the
RSPAN VLAN packets.
The redirect command makes sure that the RSPAN VLAN packets can egress to the redirect
ports. In addition, to this redirect command, the VLAN setting must be correctly configured to
make the RSPAN VLAN work correctly. That is, for the intermediate switch, the redirect port
must be tagged member port of RSPAN VLAN. For the last switch, the redirect port must be
either be a tagged member port or an untagged member port of the RSPAN VLAN based on
the users' requirements. If untagged membership is specified, the RSPAN VLAN tag will be
removed.
The redirect function will only work when RSPAN is enabled.
Multiple RSPAN VLANs can be configured with the redirect setting at the same time.
A RSPAN VLAN can be configured with the source setting and the redirect setting at the
same time.
vlan - See below:
vlan_name - Specify the RSPAN VLAN by VLAN name.
vlan_id - Specify the RSPAN VLAN by VLAN ID.
redirect - Specify output portlist for the RSPAN VLAN packets. If the redirect port is a Link
Aggregation port, there will perform the Link Aggregation behavior for RSPAN packets.
Only Administrator and Operator-level users can issue this command.
492