D-Link xStack DGS-3400 Series Reference Manual page 504

xStack
config ripng
Restrictions
Example usage:
To configure the RIPng method as poison reverse:
DGS-3450:admin#config ripng method poison_reverse
Command: config ripng method poison_reverse
Success.
DGS-3450:admin#
config ripng ipif
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable the RIPng interface state:
DGS-3450:admin# config ripng ipif System state enable
Command: config ripng ipif System state enable
Success.
DGS-3450:admin#
debug ripng state
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
®
DGS-3400 Series Layer 2 Gigabit Ethernet Managed Switch CLI Manual
poison_reverse - Configured to use split horizon with poison reverse.
Only Administrator and Operator-level users can issue this command.
Used to specify the RIPng state and metric value for one or all interfaces
config ripng ipif [<ipif_name 12> | all] {state [enable | disable] | metric <value 1-15>}(1)
This command is used to specify the RIPng state or metric value for one or all interfaces.
all - Specifies that settings will be applied to all IP interfaces.
metric - The cost value of an interface. The RIPng route that was learned from the interface
will add this value as a new route metric. The default value is 1.
state - Enable or disable the RIPng state on the specific IP interface. If the state is disabled,
then RIPng packets will not be transmitted or received by the interface. The default setting is
disabled.
Only Administrator and Operator-level users can issue this command.
Used to enable or disable the RIPng debug state globally.
debug ripng state [enable | disable]
This command is used to enable or disable RIPng debug globally.
state - The state of the RIPng debug. The default setting is disabled.
enable - Enable RIPng debug.
disable - Disable RIPng debug.
Only Administrator-level users can issue this command.
500