D-Link xStack DGS-3400 Series Reference Manual page 567

xStack
DGS-3450:admin# show syslog
Command: show syslog
Syslog Global State: Enabled
DGS-3450:admin#
config syslog host
Purpose
Syntax
Description
Parameters
®
DGS-3400 Series Layer 2 Gigabit Ethernet Managed Switch CLI Manual
Used to configure the syslog host configurations.
config syslog host <index 1-4> [severity [emergency | alert| critical | error | warning |
notice | informational | debug | <level 0-7>] | facility [local0 | local1 | local2 | local3 |
local4 | local5 | local6 | local7] | udp_port <udp_port_number> | ipaddress <ipaddr>|
state [enable | disable]](1)
This command configures the syslog host configurations. The user can choose and report a
specific level of messages to a specific host. When the user chooses a specific level for a
specific host, messages which are at that severity level or higher will be reported to the
specified host.
When the specified host doesn't exist, the prompt message, "The entry does not exist." will
be displayed and this configuration will fail.
When the IP address is invalid, the prompt message, "Invalid IP address." will be displayed
and this configuration will fail.
The prompt message, "The IP address has already been configured." will be prompted to the
user when configuring syslog hosts with "all" option and just assigning one IP address to
those hosts. This configuration will fail.
When the specified IP address already exists, the prompt message, "The host IP address
already exists." will be displayed and this configuration will fail.
host - The host index or all hosts.
severity - emergency
alert
critical
error
warning
notice
informational
debug
facility - Some of the operating system daemons and processes have been assigned facility
values. Processes and daemons that have not been explicitly assigned a facility may use any
of the "local use" facilities or they may use the "user-level" facility. Those facilities that have
been designated are shown below. This facility setting will be put in the syslog packet when it
is sent to a specific syslog server.
local0
local1
local2
local3
local4
local5
local6
local7
udp_port - The UDP port number.
ipaddr - Specify the IP address for the host.
ipv6addr - Specify the IPv6 address for the host.
Severity level 0
Severity level 1
Severity level 2
Severity level 3
Severity level 4
Severity level 5
Severity level 6
Severity level 7
user-defined facility
user-defined facility
user-defined facility
user-defined facility
user-defined facility
user-defined facility
user-defined facility
user-defined facility
563