Time Range Commands - D-Link xStack DGS-3400 Series Reference Manual

xStack
The Time Range commands are used in conjunction with the Access Profile commands listed in the previous chapter to
determine a starting point and an ending point, based on days of the week, when an Access Profile configuration will be
enabled on the Switch. Once configured here, the time range are to be applied to an access profile rule using the config
access_profile profile_id command.
NOTE: The Time Range commands are based on the time settings of the Switch. Make sure to
configure the time for the Switch appropriately for these commands using commands listed in the
Time and SNTP Commands chapter later in this manual.
The Time Range commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in
the following table.
Command
config time_range
show time_range
Each command is listed, in detail, in the following sections.
config time_range
Purpose
Syntax
Description
Parameters
®
DGS-3400 Series Layer 2 Gigabit Ethernet Managed Switch CLI Manual
Parameters
<range_name 32> [hours start_time <time hh:mm:ss> end_time <time
hh:mm:ss> weekdays <daylist> | delete]
Used to configure a time range in which an access profile rule is to be enabled.
config time_range <range_name 32> [hours start_time <time hh:mm:ss> end_time <time
hh:mm:ss> weekdays <daylist> | delete]
This command is to be used in conjunction with an access profile rule to determine a period of
time when an access profile and an associated rule are to be enabled on the Switch. Remember,
this time range can only be applied to one period of time and also, it is based on the time set on
the Switch.
range_name 32 – Enter a name of no more than 32 alphanumeric characters that will be used to
identify this time range on the Switch. This range name will be used in the config
access_profile profile_id command to identify the access profile and associated rule to be
enabled for this time range.
hours – This parameter is used to set the time in the day that this time range is to be set using
the following parameters:
• start_time <time hh:mm:ss> − Use this parameter to identify the starting time of the
time range, in hours, minutes and seconds, based on the 24-hour time system.
• end_time <time hh:mm:ss> − Use this parameter to identify the ending time of the time
range, in hours, minutes and seconds, based on the 24-hour time system.
weekdays – Use this parameter to determine the days of the week to set this time range.
• <daylist> − The user may set the days of the week here to set this time range in the
three letter format (mon, tue, wed...). To specify a day range, separate the daylist
using a dash (mon-fri would mean Monday through Friday). To specify a list of days in
a week, separate the daylist using a comma, with no spaces (mon,tue,fri would mean
Monday, Tuesday and Friday).
delete – Use this parameter to delete a previously configured time range from the system.
T
IME
584
84
R C
ANGE OMMANDS