D-Link xStack DGS-3400 Series Reference Manual page 66

xStack
DGS-3450:admin# config authen parameter attempt 9
Command: config authen parameter attempt 9
Success.
DGS-3450:admin#
show authen parameter
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display the parameters of authentication:
DGS-3450:admin# show authen parameter
Command: show authen parameter
Response timeout : 60 seconds
User attempts : 9
DGS-3450:admin#
enable admin
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable administrator level privileges:
DGS-3450:admin# enable admin
Password:********
DGS-3450:admin#
®
DGS-3400 Series Layer 2 Gigabit Ethernet Managed Switch CLI Manual
This command is used to display the parameters of authentication.
show authen parameter
Displays the parameters of authentication.
None.
Only Administrator can issue this command.
This command is used to enter the administrator level privilege
enable admin
Promote the "user" privilege level to "admin" level. When the user enters this command, the
authentication method tacacs, xtacacs, tacacs+, user-defined server groups, local_enable or
none will be used to authenticate the user. Since TACACS, XTACACS and RADIUS do not
support the "enable" function by their selves,, if the user wants to use either one of these
three protocols to enable authentication, the user must create a special account on the server
host first, which has a username of "enable", and then configure its password as the enable
password to support the "enable" function.
This command can not be used when the authentication policy is disabled.
For switches with 3-levels of privilege, this command can be used by users with user level
and operator level privileges to access the administrator privilege level.
None.
None.
62