D-Link xStack DGS-3400 Series Reference Manual page 17

xStack
DGS-3450:admin# show serial_port
Command: show serial_port
Baud Rate : 115200
Data Bits : 8
Parity Bits : None
Stop Bits : 1
Auto-Logout : 10 mins
DGS-3450:admin#
config serial_port
Purpose Used to configure the serial port.
Syntax config serial_port {baud_rate [9600 | 19200 | 38400 | 115200] | auto_logout [never | 2_minutes |
5_minutes | 10_minutes | 15_minutes]}
Description
This command is used to configure the serial port's baud rate and auto logout settings.
baud_rate [9600 | 19200 | 38400 | 115200] − The serial bit rate that will be used to communicate with
Parameters
the management host. There are four options: 9600, 19200, 38400, and 115200.
never − No time limit on the length of time the console can be open with no user input.
2_minutes − The console will log out the current user if there is no user input for 2 minutes.
5_minutes − The console will log out the current user if there is no user input for 5 minutes.
10_minutes − The console will log out the current user if there is no user input for 10 minutes.
15_minutes − The console will log out the current user if there is no user input for 15 minutes.
Restrictions Only Administrator and Operator-level users can issue this command.
Example usage:
To configure baud rate:
DGS-3450:admin# config serial_port baud_rate 115200
Command: config serial_port baud_rate 115200
Success.
DGS-3450:admin#
enable clipaging
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable pausing of the screen display when the show command output reaches the end of the page:
®
DGS-3400 Series Layer 2 Gigabit Ethernet Managed Switch CLI Manual
Used to pause the scrolling of the console screen when the show command displays more
than one page.
enable clipaging
This command is used when issuing the show command which causes the console screen to
rapidly scroll through several pages. This command will cause the console to pause at the
end of each page. The default setting is enabled.
None.
Only Administrator and Operator-level users can issue this command.
13