Mechanical Adjustment; Staple Position Adjustment - Konica Minolta bizhub 250 Service Manual

Field Service Ver. 1.0 Aug. 2005
8.

Mechanical adjustment

8.1

Staple Position Adjustment

NOTE
Make this adjustment after any of the following procedures has been performed.
• When the Stapler has been replaced.
• When staple position is misaligned.
1-Point Tilted Staple
B
C
D
1-point parallel staple
A
B
2-Point Staple
C
D
E
F
EDNord - Istedgade 37A - 9000 Aalborg - telefon 96333500
A
4349F3C506DA
8. Mechanical adjustment
1. Set the staple mode and make a
copy.
2. Check the staple position of the
paper.
• 1-Point Tilted Staple
(Paper Width: 216 to 297 mm)
279 to 297 mm: 45° tilt,
B5, B4R: 30° tilt
Measurement
Specification
position
A, C 4.4 mm
B, D 12.1 mm
• 1-Point Parallel Staple
(Paper Width: 182 to 216 mm)
Measurement
Specification
position
A 4.5 mm
B 6 mm
• 2-Point Staple
Measurement
Specification
position
C, F 6 mm
D Y
E X
Y = (paper width-X-11) / 2
X = A3R, A4: 137
B4R, B5: 114
A4R: 190
B5R: 162
Substitute above into the equation.
3. If the staple position is misaligned,
adjust with the following procedure.
Adjustment
range
—
+1 mm to -2mm
Adjustment
range
—
+1 mm to -2mm
Adjustment
range
+1 mm to -2mm
—
—
29