Konica Minolta bizhub 250 Service Manual page 636

Field Service Ver. 1.0 Aug. 2005
11. Press the Clear key and use the 10-Key Pad to set the value.
• If width B is wider than the specified range, enter a negative value.
• If width B is narrower than the specified range, enter a positive value.
Adjustment range: + 19.0 (+6.08 mm) max. and -19.0 (-6.08 mm) min.
Use the * key to switch between + and -.
12. Perform another test print and check the reference deviation.
13. Repeat the adjustment until the reference line falls within the specified range.
EDNord - Istedgade 37A - 9000 Aalborg - telefon 96333500
8. Measure the width of printed refer-
9. If width B falls within the specified
B
4061F3C515DA
10. Touch [END] to display the Registra-
4061F3E527DA
6. Mechanical adjustment
ence line B.
Specification: 11.3 mm ± 1.5 mm
range, finish the adjustment proce-
dure.
If outside the specified range, per-
form the adjustment below.
tion (FD) screen.
23