15. Initial Mode; 15.1 Initial Mode Function Setting Procedure; Exiting - Konica Minolta bizhub 250 Service Manual

15. Initial Mode

15. Initial Mode

15.1 Initial Mode Function Setting Procedure

1. Remove the Compact Flash Cover [1].
2. Press the Warm Restart switch [2].
3. When " " appears at the center on the left-hand side of the screen, enter "3" from the
10-Key Pad.
4. Enter the 8-digit service code and touch [END]. (Default value: 00000000)
NOTE
• When [END] is touched after a wrong service code has been entered, the Basic
screen reappears.
• At the fourth access after entries of three wrong access codes, [END] is not avail-
able on the screen. It is therefore necessary to turn OFF and ON the Main Power
Switch.
• If you forget the service code, it becomes necessary to replace the RAMS Board
with a new one. Take necessary steps not to forget the service code.
• The RAMS Board is not available as a replacement part. If it requires replacement,
contact Office Printing Support Division by way of CSES.
5. Select a function.
15.1.1

Exiting

• Touch [Exit].
208
EDNord - Istedgade 37A - 9000 Aalborg - telefon 96333500
[2]
Field Service Ver. 1.0 Aug. 2005
[1]
4040F3C533DA
4040F3C521DA