Fold Position Adjustment - Konica Minolta bizhub 250 Service Manual

8. Mechanical adjustment
8.2

Fold Position Adjustment

NOTE
Make this adjustment after any of the following procedures has been performed.
• When the Crease Unit has been replaced.
• When a deviation occurs in the crease.
• When fold angle adjustment has been made.
1. Enter the Booklet + Crease mode and make a copy. (A3 Size)
Exit direction
Exit direction
12. Touch [Enter].
13. Make another copy, and check the deviation.
24
EDNord - Istedgade 37A - 9000 Aalborg - telefon 96333500
2. Press the Utility/Counter key, and
3. Touch the [5/6] tab.
4. Touch [Crease/Center Staple].
4511F3E513DA
5. Select [A3] and touch [Enter].
6. Touch [Crease].
7. Check the copy of step 1 and make
4511F3E514DA
If the fold is offset as shown on the
A
left.
8. Fold the copy along the crease and
9. Touch [ ] and set the appropriate
4511F3C505DA
If the fold is offset as shown on the
B
left.
10. Fold the copy along the crease and
11. Touch [ ] and set the appropriate
4511F3C506DA
Field Service Ver. 1.0 Aug. 2005
touch [User's Choice].
the following adjustment.
measure width A.
Specification: 0 ± 1.5 mm
numeric value.
Adjustment range: 0 to +10
(1 increment 0.5 mm)
measure width B.
Specification: 0 ± 1.5 mm
numeric value.
Adjustment range: 0 to -10
(1 increment 0.5 mm)