Konica Minolta bizhub 250 Service Manual page 448

Field Service Ver. 1.0 Aug. 2005
MODE
Bit:
044
Bit Feature
7 Select threshold value for
RTN sending error trace.
6 Process TCF sending
specially.
4 Select T4 timer (Action
against line delay).
3 Take an action for com-
munication error from
overseas (Action against
LMCD-OFF).
2 Take an action for com-
munication error from
overseas (Action for fall
back).
1 Process RTN RX failure.
0 Retrain V. 34 control
channel.
EDNord - Istedgade 37A - 9000 Aalborg - telefon 96333500
Factory setting bit
7 6 5 4 3 2 1 0
1 0 0 0 0 0 0 0
Logic
0 1
32 lines 64 lines
or more or more
No Yes
3 sec 4.5 sec
Yes No
Yes No
discard not as
as error error
Yes No
(discard (not as
as error) error)
11. Soft Switch List
HEX:80
Description
Specifies # of error lines as reference of
sending RTN:
• "32 lines or more":
MCF if error lines are 0 - 31, RTN if
error lines are 32 or more
• "64 lines or more":
MCF if error lines are 0 - 31, RTP if
error lines are 32 to 63, RTN if error
lines are 64 or more
• Select "No" unless bad line is experi-
enced.
• Select "No" unless bad line is experi-
enced.
79