Konica Minolta bizhub 250 Service Manual page 532

Field Service Ver. 1.0 Aug. 2005
12.2.2 Terminal alarm
Code Description
45 • Memory overflow or nearly
full
46 • Document jamming
47 • "No print paper" or "Side
cover opened" were
detected
12.2.3 Communication errors (TX)
Code Description
33 • Protocol failure in V.34
sequence
70 • Busy tone while waiting for
initial identification signal
• Timeout or modem failure
while detecting 2nd dialing
tone
• Cannot dial due to dialing/
ringing conflict
• T1 timeout while waiting
for initial identification sig-
nal when FAX signal is not
detected
71 • T1 timeout while waiting
for initial identification sig-
nal after FAX signal is
detected
• Detected reverse polarity
while waiting for initial
identification signal
72 • Received DCN in phase B
while waiting for com-
mands other than DCN
EDNord - Istedgade 37A - 9000 Aalborg - telefon 96333500
Cause
Re Li Lo
Memory overflows or
nearly full
Feeding is not working
continuously.
Jamming in a long
document or in the
middle of a page
(Feeding is not com-
pleted even if feeding
exceeds 1 m.)
Out of print paper
Side cover was
opened while RX
Cause
Re Li Lo
Failure in remote
machine
Line failure
Failure in remote
machine
Line failure
Failure in remote
machine
Line failure
Interruption or failure
in remote machine
12. Troubleshooting
Remedy
Reset the terminal alarm and
ask the remote end for
resending.
Reload a document.
Reload a document.
Load print paper.
Close the side cover.
Remedy
Try another remote machine.
Try another line.
Try another remote machine.
Try another line.
Try another remote machine.
Try BACK to BACK commu-
nication.
Check the remote system
and retry TX.
163