Mechanical Adjustment; Mis-Centering Adjustment Of The Trays 1 And 2 - Konica Minolta bizhub 500 Service Manual

Field Service Ver.2.0 Jan. 2007

11. MECHANICAL ADJUSTMENT

11.1 Mis-centering adjustment of the trays 1 and 2

This adjustment is made when there occurs a mis-centering that cannot be adjusted in the service mode.
A. Procedure
[4]
[2]
[3]
[1]
Confidential – for internal use only, do not distribute
[3] [2]
[1]
50gaf3c014na
50gaf3c015na
11. MECHANICAL ADJUSTMENT
1. Pull out the tray [1].
2.
If there remains any paper, remove it thoroughly.
3.
When the paper guide [2] is set to the small size
position, expand it.
4.
Loosen the 2 screws [3].
5.
Move the paper guide [2] and adjust the center
position with the marking-off [4] as a guide.
6.
Tighten the 2 screws [3].
7.
Set the tray with paper put in it.
8.
Conduct the copy/print operation and check to
see if the mis-centering between the center [1] of
the paper and the center [2] of the copied image
is within a standard value (± 3 mm or less [3]).
9.
When the value is not within the standard value,
repeat steps 1 to 8 until the standard value can be
obtained.
305