Communication Error Codes - Konica Minolta bizhub 250 Service Manual

12. Troubleshooting

12.2 Communication Error Codes

NOTE
• Cause - Re: Remote, Li: Line, Lo: Local
12.2.1 Errors in operations
Code Description
00 • Received DIS but no doc-
ument in local terminal
• Polling Reception is
requested
• Software failure at time of
connection
01 • Document pulled out while
transmitting.
• Document size was too
small
02 • Illegal dialing operation
(Example; dialing * or #
with DP setting)
03 • Mismatched TX password Sender's password
04 • Mismatched RX password Sender's password
05 • Mismatched password
while polling
06 • Remote system has no
relay function
07 • Remote system has not
confidential communica-
tion function
09 • Incompatibility (Example;
no document in local sys-
tem while polling RX)
• TX failure due to mis-
match of communication
type and/or transmission
speed
10 • Error in F code TX
11 • Error in F code RX
162
EDNord - Istedgade 37A - 9000 Aalborg - telefon 96333500
Cause
Re Li Lo
Error in operation
Error in operation at
remote end
Error in operation
Error in setting up
Error in registration
and receiver's are not
matched.
and receiver's are not
matched.
Incorrect password
was entered for set-
ting up polling.
Failure in remote
machine
Failure in remote
machine
Error in operation on
remote side
Transmission speeds
are set 4800/2400 bps.
Remote machine has
only V.29.
Failure in remote
machine
Failure in remote
machine
Field Service Ver. 1.0 Aug. 2005
Remedy
Reload a document and retry
TX.
Ask to reload a document
and retry TX.
Reload a correct document
and retry TX.
Check the soft switch (MODE
006 Bit5 & MODE 011 Bit 5).
Check the registered one-
touch dialing number.
Check the group password of
both sides.
Check the group password of
both sides.
Check the status of the
remote machine and the local
password.
Check the status of the
remote machine.
Check the status of the
remote machine.
Ask the remote end to reload
the document again.
Check the soft switch (MODE
049 Bit 4 -0).
Check the maximum trans-
mission speed for each one-
touch dialing (only for regis-
tration in maintenance fea-
tures).
Check the status of the
remote machine.
Check the status of the
remote machine.