Konica Minolta bizhub 250 Service Manual page 170

Field Service Ver. 1.0 Aug. 2005
(6) Network Board Set
<Network Board Speed>
Functions • To set the data transfer rate of the Network Board.
Use • To set a specific network data transfer rate.
• The default setting is "Auto".
NOTE
Setting/
• Be sure to set the correct transfer rate so as to ensure that communications are
Procedure
carried out correctly.
• If the network data transfer rate has been changed, be sure to turn OFF the Main
Power Switch of the machine, wait for 10 sec. or more, and then turn the switch
ON again.
<Duplex>
Functions • To set the packet transmission/reception mode when the switching hub is connected.
• To change the setting between Full Duplex and Half Duplex.
Use
• Use this function when Network Board Speed has been set to [100M] or [10M].
• The default setting is "Half Duplex".
Setting/
NOTE
Procedure
• If the Duplex setting has been changed, be sure to turn OFF the Main Power
Switch of the machine, wait for 10 sec. or more, and then turn the switch ON
again.
B. DNS Settings
Functions • To set the DNS Server.
Use • To enter DNS Server.
• The default setting is "NO".
<Host Name>
1. Touch the [Host Name].
2. Enter the host name of the local machine from the 10-Key Pad or the keyboard on the
screen and then touch [Enter].
Setting/
<Domain Name>
Procedure
1. Touch the [Domain Name].
2. Enter the domain name of the local machine from the 10-Key Pad or the keyboard on
the screen and then touch [Enter].
<DNS Server Address>
• IP address Version 4 format
[0 to 255] . [0 to 255] . [0 to 255] . [0 to 255]
* Up to three places can be set.
C. Machine Name
Functions • To set the name of the machine.
Use • To enter the name of the machine.
1. Touch the [Machine Name].
Setting/
2. Enter the machine name of the local machine from the 10-Key Pad or the keyboard on
Procedure
the screen and then touch [Enter].
EDNord - Istedgade 37A - 9000 Aalborg - telefon 96333500
"Auto" 100M
"Half Duplex" Full Duplex
YES "NO"
9. Utility/Counter Mode
10M
131