NEC Univerge SV8100 Features And Specifications Manual page 766

Hide thumbs Also See for Univerge SV8100:

Table of Contents

Your phone and DSS Console can set and monitor the status of all your guest rooms: Checked In,

Checked Out, Maid Required and Maid in Room. Maximize room usage by coordinating your cleaning

staff and reservation desk. For example, you can dial simple codes to set a room status.

Room Status Printouts

The Room Status Printouts give you a concise overview of the status of all your guest rooms at a glance.

The printouts provide up to the minute reports showing Room Status, Room Call Restriction, Do Not

Disturb, Message Waiting and Wake Up Calls. If your cleaning staff needs to know which rooms to

clean, for example, just print out the report showing Room Status. This printout requires a connection to

the system using either a serial CTA adapter, USB CTU adapter or IP post on the CPU. Only DTH

telephones are supported with CTA/CTU on SV8100.

DSS Console Monitoring

Your DSS Console provides room monitoring abilities. You can see at a glance which rooms have Wake

Up Calls set or messages waiting. In addition, you can still use your console for business mode features.

Do Not Disturb

A guest can activate DND anytime they need privacy (for example, if they need to work uninterrupted).

Do Not Disturb (DND) blocks the room telephone incoming calls and Paging announcements. This can

be set from the room phone or attendant phone.

Flexible Numbering Plan

To simplify dialing guests and services in your facility, customize your system to have room numbers

match phone extension numbers. For example, if the rooms on the first floor are numbered 100~120, the

corresponding room extensions should also be 100~120.

The following features were added in Version 7000 or higher SV8100 software:

View current room status in Program 42-02-03 via Web Pro and Phone Pro.

Use Program 42-01-06 to enable (1) or disable (0) the ability to change any room status to

another room status.

Set room status on check out using Programs 42-06-07 and 42-06-08.

When setting room status automatically on check out, you cannot set a room to Room

Clean (Occupied) from the room using access code 640. This status can only be changed

from the front desk telephone (access code 641).

When Program 42-01-06 is disabled, valid room status changes are limited. Refer to the

PMS Developer Guide for information on valid status changes.

UNIVERGE SV8100

Chapters

Table of Contents