Ken-Keypad Enable - Christie Mirage SST Technical Reference

Command Description
This command is only available if video electronics are
on.
Examples
Disable test patterns:
(ITP 0)
Set the test pattern to the grid pattern:
(ITP 1)
Enable a moving grid test pattern:
(ITP+GRDM 1)
KEN–Keypad Enable
Enables or disables the IR or wired keypad sensors.
Commands
Command Description
KEN+FRNT <0 | 1> Enables or disables the IR keypad sensor.
(Saved value)
KEN+HDBT <0 | 1> Enables IR over HDBaseT. (Saved value)
KEN+REAR <0 | 1> Enables or disables the rear IR keypad
sensor. (Saved value)
KEN+WIRE? Returns the current wired jack enabled
state. (Read-only)
KEN+WIRE <0 | 1> Enables or disables the wired keypad sensor.
(Saved value)
Examples
Get the current wired jack enabled state:
(KEN+WIRE?)
Disable the front IR sensor:
(KEN+FRNT 0)
Disable the rear IR sensor:
(KEN+REAR 1)
Mirage SST Technical Reference–Serial Commands
020-103005-03 Rev. 1 (01-2021)
Copyright © 2021 Christie Digital Systems USA, Inc. All rights reserved.
Serial API commands
Values
Values
0 = Disables the front IR keypad sensor
1 = Enables the front IR keypad sensor
(Default)
0 = Disables IR over HDBaseT (Default)
1 = Enables IR over HDBaseT
0 = Disables the rear IR keypad sensor
1 = Enables the rear IR keypad sensor
(Default)
—
0 = Disables the wired keypad jack
1 = Enables the wired keypad jack (Default)
40