Clutch Release Camshaft - Suzuki GW250 Service Manual

3-46 ENGINE

CLUTCH RELEASE CAMSHAFT

DISASSEMBLY
• Pull out the clutch release camshaft 1.
• Remove the oil seal 2 and washer 3.
• Remove the bearing 4.
INSPECTION
Inspect the clutch release camshaft of wear bend.
Replace the camshaft if there is anything unusual.
REASSEMBLY
Reassemble the clutch release camshaft in the reverse order of
disassembly. Pay attention to the following points:
• Apply engine oil to the new bearing 1.
• Apply grease to the camshaft sliding surface of the clutch
release camshaft 1 and new oil seal lip.
 99000-25010: SUZUKI SUPER GREASE "A"
• Pass the new oil seal 2 into the upper crankcase 3 at 0 –
0.5 mm (0.02 in) depth A from the upper crankcase side sur-
face.
NOTE:
After installing the clutch release camshaft, be sure to check the
clutch release camshaft operation.
or equivalent