Suzuki GW250 Service Manual page 364

8-80 CHASSIS
• Stake the joint pin by turning (approximately 7/8 turn) the
pressure bolt "A" 3 with the bar until the pin end diameter
becomes the specified dimension.
• After joining of the chain has been completed, check to make
sure that the link is smooth and no abnormal condition is
found.
 Pin end diameter specification A
DID 5.50 – 5.80 mm (0.217 – 0.228 in)
Should any abnormal condition be found, reassemble
the chain link using the new joint parts.
• Adjust the drive chain, after connecting it. (2-17)