Suzuki GW250 Service Manual page 356

8-72 CHASSIS
• Apply grease to the push rod end.
 99000-25100: SUZUKI SILICONE GREASE or equivalent
• Install a new O-ring 1.
• Tighten the master cylinder mounting bolts 2 and lock-nut 3
to the specified torque.
 Rear brake master cylinder mounting bolt:
Rear brake master cylinder rod lock-nut:
• Install the brake hose with union bolt and new seal washers.
• After setting the brake hose union to the stopper, tighten the
union bolt 4 to the specified torque.
 Brake hose union bolt: 23 N·m (2.3 kgf-m, 16.5 lbf-ft)
• Bleed air from the brake system after installing the master cyl-
inder. (2-21 to -22)
• Route the rear brake hose properly. (10-24)
• Adjust the brake pedal height. (2-21)
10 N·m (1.0 kgf-m, 7.0 lbf-ft)
18 N·m (1.8 kgf-m, 13.0 lbf-ft)