Suzuki GW250 Service Manual page 63

• Remove the cylinder head gasket 4, dowel pins 5 and cam
chain guide 6.
• Remove the water inlet connector 7.
• Remove the cylinder bolts 1 and cylinder 8.
NOTE:
If the cylinder does not come off, lightly tap it with a plastic ham-
mer.
• Remove the gasket 9 and dowel pins 0.
PISTON
• Place a clean rag over the cylinder base so as not to drop the
piston pin circlip into the crankcase.
• Remove the piston pin circlip 1.
• Remove the piston 2 by drawing out the piston pin 3.
NOTE:
Scribe the cylinder number on the piston head.
STARTER MOTOR
• Remove the starter motor 1.
ENGINE 3-15