Brake Fluid Replacement - Suzuki GW250 Service Manual

• Push the piston all the way into brake caliper.
• Install the new brake pads 5.
NOTE:
* Replace the brake pads as a set, otherwise braking perfor-
mance will be adversely affected.
* Make sure that the detent A of the pad is seated onto the pad
guide on the caliper bracket.
• Tighten the brake caliper mounting bolt 3, pad mounting pin
2 and pad pin plug 1 to the specified torque.
 Rear brake caliper mounting bolt:
Rear brake pad mounting pin:
Rear brake pad pin plug: 2.5 N·m (0.25 kgf-m, 2.0 lbf-ft)
• After replacing the brake pads, pump the brake pedal several
times to check for proper brake operation and then check the
brake fluid level.

BRAKE FLUID REPLACEMENT

• Remove the brake fluid reservoir mounting bolt 1.
• Remove the brake fluid reservoir cap 2 and diaphragm.
• Replace the brake fluid in the same manner as the front
brake. (8-54)
 Specification and Classification: DOT 4
• Bleed air from the brake system. (2-21 to -22)
23 N·m (2.3 kgf-m, 16.5 lbf-ft)
18 N·m (1.8 kgf-m, 13.0 lbf-ft)
CHASSIS 8-65