9-18 ELECTRICAL SYSTEM
SIDE-STAND/IGNITION INTERLOCK
SYSTEM PARTS INSPECTION
Check the interlock system for proper operation. If the interlock
system does not operate properly, check each component for
damage or abnormalities. If any abnormality is found, replace
the component with a new one.
SIDE-STAND SWITCH INSPECTION
• Remove the right frame cover. (8-4)
• Disconnect the side-stand switch coupler 1.
• Measure the voltage between G and B/W lead wire.
If the resistance is out of specification, replace the side-stand
switch.
09900-25008: Multi circuit tester set
Tester knob indication: Diode test ()
ON
(Side-stand up)
OFF
(Side-stand down)
NOTE:
If the tester reads under 1.4 V when the tester probes are not
connected, replace its battery.
SIDE-STAND RELAY INSPECTION
• Remove the fuel tank. (5-2)
• Remove the side-stand relay 1.
First, check for insulation with the tester between terminals A
and B. Next, check for continuity between A and B with 12 V
voltage applied, positive + to terminal C and negative - to ter-
minal D. If continuity does not exist, replace the relay with a
new one.
09900-25008: Multi circuit tester
Tester knob indication: Continuity test ()
G (+ probe)
B/W (- probe)
0.4 – 0.6 V
1.4 V and more
(Tester's battery voltage)