Suzuki GW250 Service Manual page 293

• Remove the brake disc 1.
• Remove the dust seals 2 on both sides using the special
tool.
 09913-50121: Oil seal remover
AXLE SHAFT
Using a dial gauge, check the axle shaft for runout and replace it
if the runout exceeds the limit.
 09900-20607: Dial gauge
09900-20701: Dial gauge chuck
09900-21304: V blocks
 Wheel axle runout:
Service Limit: 0.25 mm (0.010 in)
WHEEL
Make sure that the wheel runout checked as shown does not
exceed the service limit. An excessive runout is usually due to
worn or loosened wheel bearings and can be reduced by replac-
ing the bearings. If bearing replacement fails to reduce the
runout, replace the wheel.
 Wheel rim runout:
Service Limit (Axial and Radial): 2.0 mm (0.08 in)
CHASSIS 8-9