Rear Combination Light Installation - Suzuki GW250 Service Manual

REAR COMBINATION LIGHT INSTALLATION

1 Brake/Tail light
2 Rear fender
3 Rear frame center cover
4 License plate light
5 Rear turn signal light
6 TO sensor
*2
*3
Cut the tip of clamp after clamping the lead wires.
*1 After clamping the rear turn signal light lead wire and license plate light lead
wire, pass the lead wires inside the hole of the rear fender. Do not slacken.
When installing the TO sensor, do not
*2
damage the brake/tail light bracket.
Set the cushion of brake/tail light to the
*3
rib of the rear frame center cover.
SERVICING INFORMATION 10-39
A
*1
VIEW A

ITEM N·m kgf-m lbf-ft
A
7 0.7 5.0