Removal; Inspection And Disassembly - Suzuki GW250 Service Manual

8-8 CHASSIS

REMOVAL

NOTE:
Do not operate the brake lever with the caliper removed.
• Loosen the front axle pinch bolt 1.
• Loosen the front axle 2 using the special tool.
 09900-18710: Hexagon socket (12 mm)
• Raise the front wheel off the ground and support the motorcy-
cle with a jack or a wooden block.
* Do not support the motorcycle with the exhaust pipe.
* Make sure that the motorcycle is supported securely.
• Draw out the front axle 2 and remove the front wheel 3.
• Remove the collar 4 (LH only).

INSPECTION AND DISASSEMBLY

TIRE........................................................... (2-23, 8-73)
BRAKE DISC............................................. (8-58)
DUST SEAL
Inspect the dust seal for wear or damage. If any damage is
found, replace the dust seal with a new one.