Suzuki GW250 Service Manual page 323

• Tighten the rear sprocket nuts to the specified torque.
 Rear sprocket nut: 49 N·m (4.9 kgf-m, 35.5 lbf-ft)
NOTE:
Stamped mark A on the sprocket must face outside.
• Install the spacer 2.
BRAKE DISC
• Make sure that the brake disc is clean and free of any greasy
matter.
• Apply thread lock to the disc bolts and tighten them to the
specified torque.
 99000-32130: THREAD LOCK CEMENT SUPER "1360"
 Brake disc bolt (Rear): 23 N·m (2.3 kgf-m, 16.5 lbf-ft)
• Install the collar 1.
REAR AXLE
• Install the rear wheel with the rear axle and tighten the rear
axle nut 1.
• Adjust the drive chain slack after installing the rear wheel.
(2-18)
• Tighten the rear axle nut 1 to the specified torque.
 Rear axle nut: 65 N·m (6.5 kgf-m, 47.0 lbf-ft)

After installing the rear wheel, pump the brake pedal
several times to check for proper brake operation.
or equivalent
CHASSIS 8-39