Using The Multi Circuit Tester - Suzuki GW250 Service Manual

USING THE MULTI CIRCUIT TESTER

• Properly use the multi circuit tester + and - probes.
Improper use can cause damage to the motorcycle and
tester.
• If the voltage and current values are not known, begin mea-
suring in the highest range.
• When measuring the resistance, make sure that no voltage is
applied. If voltage is applied, the tester will be damaged.
• After using the tester, be sure to turn the switch OFF.
 09900-25008: Multi circuit tester set

Before using the multi circuit tester, read its instruc-
tion manual.
NOTE:
* When connecting the multi circuit tester, use the nee-
dle-pointed probe to the back side of the lead wire coupler and
connect the probes of tester to them.
* Use the needle-pointed probe to prevent the rubber of the
water proof coupler from damage.
* When using the multi circuit tester, do not strongly touch the
terminal of the ECM coupler with a needle-pointed tester
probe to prevent the terminal damage or terminal bend.
 09900-25009: Needle-pointed probe set
ELECTRICAL SYSTEM 9-5