Generator; Water Pump - Suzuki GW250 Service Manual

3-44 ENGINE
PRIMARY DRIVE GEAR
Rotate the primary drive scissors gear by finger to inspect for
smooth rotation.
If there are signs of any abnormalities, replace the springs.
• When installing the primary drive scissors gear, align the
punch mark A on the scissors gear with the rib B.

GENERATOR

INSPECTION (9-10 to -11)
REASSEMBLY
• When replacing the generator coil 1 or CKP sensor 2, apply
thread lock to the generator starter set bolts 3 and CKP sen-
sor mounting bolts 4 and tighten them to the specified
torque.
 99000-32110: THREAD LOCK CEMENT SUPER "1322"
 Generator starter set bolt: 11 N·m (1.1 kgf-m, 8.0 lbf-ft)
CKP sensor mounting bolt: 5.5 N·m (0.55 kgf-m, 4.0 lbf-ft)
NOTE:
Be sure to install the grommet A to the generator cover.

WATER PUMP

7-14
or equivalent