Clutch Lever Removal And Installation; Clutch Push Rod (Left) / Clutch Release Camshaft Removal And Installation - Suzuki SFV650 Service Manual

Clutch Lever Removal and Installation

Removal
1) Disconnect the clutch cable (1) (Clutch lever side).
Refer to "Clutch Cable Removal and Installation
(Page 5C-2)".
2) Remove the following parts from the left handle bar.
a) Rear view minor (2)
b) Clutch lever position switch coupler (3)
c) Left handlebar switch box (4)
d) Handlebar balancer (5)
e) Grip rubber (6)
f) Clutch lever assembly (7)
5
6
3) Remove the clutch lever position switch (8) and
clutch lever (9).
B944H15306026
1
I944H1530006-01
2
7
3
4
I944H1530007-02
8
9
I944H1530008-03
Installation
Install the clutch lever in the reverse order of removal.
Pay attention to the following points:
• Apply grease to the clutch lever pivot bolt.
: Grease 99000–25100 (SUZUKI SILICONE
GREASE or equivalent)
• Install the left handlebar components. Refer to
"Handlebars Removal and Installation in Section 6B
(Page 6B-3)".
• After install the removed parts, adjust the clutch cable
play. Refer to "Clutch System Inspection in Section 0B
(Page 0B-14)".
Clutch Push Rod (Left) / Clutch Release
Camshaft Removal and Installation
Removal
1) Remove the generator cover. Refer to "Generator
Removal and Installation in Section 1J (Page 1J-4)".
2) Remove the clutch push rod (1).
3) Remove the clutch push rod cap (2).
Clutch: 5C-4
I944H1530009-01
B944H15306027
1
I944H1530010-01