Rear Combination Light Removal And Installation - Suzuki GSX-R600 Manual

Rear Combination Light Removal and
Installation
Removal
1) Remove the frame cover assembly. Refer to
"Exterior Parts Removal and Installation in Section
9D (Page 9D-11)".
2) Disconnect the combination light coupler (1).
3) Disconnect the combination light lead wire from its
clamp (2).
4) Remove the rear combination light (3).
2
5) Remove the combination light brackets (upper and
lower) (4).
B837H19206009
3
1
I837H1920022-01
4
I837H1920023-01
Installation
Install the rear combination light in the reverse order of
removal. Pay attention to the following point:
• Tighten the combination light mounting bolts (1) to the
specified torque.
NOTE
When reusing the removed bolts (1), apply a
small quantity of the thread lock to them.
Tightening torque
Combination light mounting bolt (a): 2.8 N·m (
0.28 kgf-m, 2.0 lb-ft)
: Thread lock cement 99000–32110
(THREAD LOCK CEMENT SUPER 1322 or
equivalent)
Lighting Systems: 9B-7
1
(a)
I837H1920024-01