Front Crankcase Cover - Honda TRX680FA Service Manual

DRIVETRAIN SYSTEM
Install the shift valve body assembly with the six
bolts and tighten them securely.
BOLTS
Connect the solenoid valve 2P (Black and Brown) '
connectors.
Connect the A/T clutch pressure control 2P (Black)
connector.
Install the valve body cover with the two setting
bolts and tighten them.
Install the wire clip over the wire harness and into
the body cover.
Perform the transmission oil pressure check, if nec-
essary (page 14-12).
Install the following:
- inner fender (page 3-9)
- front mud guard (page 3-8)
- engine side cover (page 3-17)
FRONT CRANKCASE COVER
REMOVAL
Remove the following:
- front mud guards (page 3-8)
- inner fenders (page 3-9)
- front center grille (page 3-10)
- center mud guards (page 3-7)
- engine side covers (page 3-17)
- engine guard (page 3-17)
- front propeller shaft (page 8-6).
- water pump (page 7-14)
- shift valve body (page 14-47)
SHIFT SOLENOID CONNECTORS
A/T CLUTCH PC SOLENOID
CONNECTOR (long wire)
oil pipes
O-rings
(by removing each joint bolt)
OILPIPCS
O-RINGS
14-54