Honda TRX680FA Service Manual page 106

LUBRICATION SYSTEM
SERVICE INFORMATION
GENERAL
ACAUTION
Used engine oil may cause skin cancer if repeatedly left in contact with the skin for prolonged periods. Although this is
unlikely unless you handle used oil on a daily basis, it is still advisable to thoroughly wash your hands with soap and
water as soon as possible after handling used oil.
This section covers service of the oil pump and oil cooler.
For oil level check, oil change and filter replacement, refer to page 4-10.
The service procedures in this section can be performed with the engine installed in the frame.
When removing and installing the oil pump, use care not to allow dust or dirt to enter the engine.
If any portion of the oil pump is worn beyond the specified service limits, replace the oil pump as an assembly.
After oil pump, oil cooler and/or oil hoses have been installed, check for oil leaks.
SPECIFICATIONS
Unit: mm (in)
ITEM
Engine oil capacity After draining
After draining/filter
change
After disassembly
Recommended engine oil
Oil pressure at 5,000 rpm (min
1
)/80°C (176°F)
Oil pump rotor Tip clearance
Body clearance
Side clearance
STANDARD
2.7 liters (2.9 US qt, 2.4 Imp qt)
2.9 liters (3.1 US qt, 2.6 Imp qt)
4.1 liters (4.3 US qt, 3.6 Imp qt)
Pro Honda GN4 or HP4 (without molyb-
denum additives) 4-stroke oil (U.S.A.
and Canada), or Honda 4-stroke oil
(Canada only), or an equivalent motor-
cycle oil
API service classification SG or Higher
(except oils labeled as energy conserv-
ing on the circular API service label)
JASO T 903 standard: MA
Viscosity: SAE 10W-40, 5W-30
785 kPa (8.0 kgf/cm
2
,114 psi)
0.15(0.006)
0.12-0.22(0.005-0.009)
0.02-0.09(0.001 -0.004)
SERVICE LIMIT
-
—
-
-
0.20 (0.008)
0.25(0.010)
0.11 (0.004)
TORQUE VALUES
Oil pump driven sprocket bolt 12N-m(1.2kgf-m, 9 Ibf-ft) Apply locking agent to the threads.
TOOLS
Oil pressure gauge set
07406-0020005
or 07ZMJ-HN2A100 and 07AMJ-
HN8A100 (U.S.A. Only)
5-3