Honda TRX680FA Service Manual page 400

REAR WHEEL/SUSPENSION
Install the hub nut and tighten it to the specified
torque and further tighten until its grooves align
with the cotter pin hole.
TORQUE: 137 N m (14.0 kgf m, 101 Ibf-ft)
Install a new cotter pin.
Install the wheel (page 16-6).
COTTER PIN
REAR SHOCK ABSORBER/
SUSPENSION ARM
SHOCK ABSORBER REMOVAL
Remove the rear wheel (page 16-6).
Remove the seat (page 3-4).
Support the knuckle with a support block.
Remove the following:
- upper arm pivot nut and bolt (to disconnect the
upper arm)
- seal caps
- pivot collar (to disconnect the knuckle)
mounting nut and bolt
shock absorber
NUT
SHOCK ABSORBER~1
16-10