Nuts, Bolts, Fasteners; Wheels/Tires; Steering Shaft Holder Bearing - Honda TRX680FA Service Manual

MAINTENANCE
Install the spark arrester with a new gasket and
tighten the bolts securely.
NUTS, BOLTS, FASTENERS
Check that all chassis nuts and bolts are tightened to
their correct torque values (page 1-13).
Check that all cotter pins, safety clips, hose clamps
and cable stays are in place and properly secured.
WHEELS/TIRES
Tire pressure
should be checked
when the tires are
cold.
Check the tire pressure with the tire pressure gauge.
RECOMMENDED TIRE PRESSURE:
Front: Standard: 30 kPa (0.30 kg/cm
2
, 4.4 psi)
Minimum: 26 kPa (0.26 kg/cm
2
, 3.8 psi)
Maximum: 34 kPa (0.34 kg/cm
2
, 5.0 psi)
With cargo: 30 kPa (0.30 kg/cm
2
, 4.4 psi)
Rear: Standard: 25 kPa (0.25 kg/cm
2
, 3.6 psi)
Minimum: 22 kPa (0.22 kg/cm
2
, 3.2 psi)
Maximum: 28 kPa (0.28 kg/cm
2
, 4.0 psi)
With cargo: 25 kPa (0.25 kg/cm
2
, 3.6 psi)
Check the tires for cuts, embedded nails, or other
damage.
Measure the tread depth at the center of the tires.
Replace the tires when the tread depth reaches the
following limit.
MINIMUM TREAD DEPTH (Front/rear):
4.0 mm (0.16 in)
Raise the wheel off the ground and check the hub,
knuckle bearings or tie-rod ball joints for excessive
play or abnormal noise.
STEERING SHAFT HOLDER BEARING
Raise the front wheels off the ground and support
the vehicle securely.
Check that the handlebar moves freely from side to
side.
If the handlebar moves unevenly, binds, or has hori-
zontal movement, inspect the steering shaft holder
bushing and bearing (page 15-28).
4-22