Honda TRX680FA Service Manual page 252

ALTERNATOR/STARTER CLUTCH
Install the starter driven gear while turning it clock- _ „ . . „ . .
wise.
INSTALLATION
Lubricate the needle bearing with molybdenum oil
solution. Install the washer and bearing onto the
crankshaft.
Install the woodruff key into the key groove.
Clean any oil from the tapered portion of the crank-
shaft and flywheel thoroughly.
Install the flywheel/starter driven gear by aligning
the key-way with the key on the crankshaft.
Apply engine oil to the pulley bolt threads and seat-
ing surface.
Install the starter driven pulley, aligning the bosses
with the grooves in the crankshaft, and secure it
with the bolt.
Hold the driven pulley using the special tool and
tighten the bolt.
TOOL:
Recoil pulley holder 07SMB-HM70100
TORQUE: 108 N-m (11.0 kgf-m, 80 Ibf-ft)
Loosen the pulley bolt, and remove the tool, bolt
and driven pulley.
Install the rear crankcase cover (page 12-7).
PULLEY HOLDER
11-16