Honda TRX680FA Service Manual page 149

FUEL SYSTEM (PGM-FI)
QUICK CONNECT FITTING
INSTALLATION
• Always replace the retainer of the quick connect
fitting and joint rubber when the fuel feed hose is
disconnected.
• If any retainer needs replacing, use the same
manufacture's retainer as the ones being
removed (The several manufactures feature dif-
ferent retainer specifications).
• If any damage or cut-out on the rubber cap,
replace it with a new one.
• Do not bent or twist the fuel feed hose.
1. Insert a new retainer into the connector.
2. Set a new joint rubber to the fuel pipe as shown.
3. Align the quick connect fitting with the pipe and
align the new retainer locking pawls with the
connector grooves in the rubber lock piece.
Then press the quick connect fitting onto the
pipe until both retainer pawls lock with a
"CLICK".
If it is hard to connect, put a small amount of
engine oil on the pipe end.
4. Make sure the connection is secure and that the
pawls are firmly locked into place; check visually
and by pulling the connector.
RETAINER
CONNECTOR
CONNECTOR
LOCKING
PAWLS
JOINT RUBBER
CONNECTOR
6-33