Honda TRX680FA Service Manual page 351

DRIVETRAIN SYSTEM
All shift clutches Clean the inner surface of the clutch drum thor-
(1st, 2ndand3rd) oughly and blow through the oil holes in the drum
use the following boss and check valve in the piston.
proce ure. ^pp|y
e n
g |
n e o
j |
t 0 n e w
O-rings and install them
into the piston groove.
Place the clutch piston into the clutch drum in the
direction shown.
DRUM
Be careful not to Install the piston while turning it to ensure proper
pinch the O-rings seating.
with too much
force.
PISTON
Place the following into the clutch drum.
- return spring
- spring retainer
- snap ring
Install the special tools while adjusting their posi-
tion carefully (page 14-65).
To prevent loss of Compress the return spring by tightening the nut.
spring tension, do
not compress more
than necessary.
Align the end gap Install the snap ring into the groove in the drum
with the groove (3 boss properly.
SPECIAL TOOLS
SPRING
RETAINER SNAP RING
places) in the spring
retainer.
Loosen the special tools and remove them.
SNAP RING
14-69