Honda TRX680FA Service Manual page 304

DRIVETRAIN SYSTEM
Turn the ignition switch ON, read the gear position
indicator " — " or 4WD indicator blinks, the number
of blinks indicates the current DTC.
Refer to the troubleshooting index (page 14-24).
When retrieving the Freeze DTC, refer to the follow-
ing procedures.
1. Turn the ignition switch OFF and remove the
steering cover (page 3-5).
2. Remove the dummy connector and short the
DLC terminals using the special tool.
TOOL:
SCS connector 070PZ-ZY30100
CONNECTION: Brown/red - Green
3. Turn the ignition switch to ON, read the gear
position indicator " — " or 4WD indicator blinks,
the number of blinks indicates the freeze DTC.
Refer to the troubleshooting index (page 14-24).
GEAR POSITION INDICATOR
CLEARING DTC
Connect the HDS Pocket Tester to the DLC (page 6-
14).
Clear the DTC with the HDS while the engine is
stopped.
To clear the DTC without HDS, refer to the following
procedure.
How to clear the DTC without HDS
NOTE:
• When clearing the Drivetrain DTC as follows, the
PGM-FI DTC would also be cleared at the same
time, check the MIL blinks and troubleshoot the
PGM-FI system before readout/clearing the Driv-
etrain DTC.
1. Turn the ignition switch OFF and remove the
steering cover (page 3-5).
14-22