Honda TRX680FA Service Manual page 418

BRAKE SYSTEM
Pivot the caliper body up and remove the brake
pads from the caliper bracket.
Always replace the Install new brake pads into the caliper bracket prop-
brake pads in pairs erly as s h o w n .
to ensure even disc
pressure.
BRAKE PADS
Lower the caliper body, install the caliper pin bolt
and tighten it.
TORQUE: 23 I M m (2.3 kgf-m, 17 Ibf-ft)
Squeeze the front brake lever to seat the caliper pis-
ton against the pad.
CALIPER BODY
SLIDE PIN BOLT
REAR BRAKE PAD REPLACEMENT
Remove the right rear wheel (page 16-6).
Remove the bracket pin retaining bolt and bracket
pin bolt.
Remove the caliper body from the caliper bracket.
Remove the brake pads from the caliper bracket.
Always replace the Install new pad onto the caliper bracket properly so
brake pads in pairs that the pin on the pad is facing to the piston.
to ensure even disc
pressure.
RETAINING BOLT
BRAKE PADS
17-11