Service Rules - Honda TRX680FA Service Manual

GENERAL INFORMATION
SERVICE RULES
1. Use genuine Honda or Honda-recommended parts and lubricants or their equivalents. Parts that do not meet Honda's
design specifications may cause damage to the motorcycle.
2. Use the special tools designed for this product to avoid damage and incorrect assembly.
3. Use only metric tools when servicing the motorcycle. Metric bolts, nuts and screws are not interchangeable with
English fasteners.
4. Install new gaskets, O-rings, cotter pins, and lock plates when reassembling.
5. When tightening bolts or nuts, begin with the larger diameter or inner bolt first. Then tighten to the specified torque
diagonally in incremental steps unless a particular sequence is specified.
6. Clean parts in cleaning solvent upon disassembly. Lubricate any sliding surfaces before reassembly.
7. After reassembly, check all parts for proper installation and operation.
8. Route all electrical wires as show in the Cable and Harness Routing (page 1-20).
ABBREVIATION
Throughout this manual, the following abbreviations are used to identify the respective parts or systems.
Abbrev. term
PGM-FI
MAP sensor
TP sensor
ECT sensor
IAT sensor
CKP sensor
VS sensor
EOT sensor
IACV
PCM
(ECM/TCM)
EEPROM
DLC
SCS connector
HDS
DTC
MIL
A/T
Clutch PC solenoid
4WD
ESP
GPS
Full term
Programmed Fuel Injection
Manifold Absolute Pressure sensor
Throttle Position sensor
Engine Coolant Temperature sensor
Intake Air Temperature sensor
Crankshaft Position sensor
Vehicle Speed sensor
Engine Oil Temperature sensor
Idle Air Control Valve
Powertrain Control Module
(Engine Control Module/Transmission Control Module)
Electrically Erasable Programmable Read Only Memory
Data Link Connector
Service Check Short connector
Honda Diagnostic System
Diagnostic Trouble Code
Malfunction Indicator Lamp
Automatic Transmission
Clutch Pressure Control solenoid
4 Wheel Drive
Electric Shift Program
Global Positioning System
1-2